Lishen rubber and plastic factory introduces the use of luminous word edge instructions

Directions for use of luminous word border:

1. First use the engraving machine to carve the acrylic board (3MM thick is appropriate) into characters.

2. Glue the glowing sideband to the engraved or blister words with 3 seconds of glue. Be careful not to let the glue flow to the surface of the board

3. Then use the engraving machine to carve the PVC board into bottom characters (thus forming a word and a bottom word

4. Fix the LED lamp on the bottom plate and stick it with glue.

5. Put the PVC button of the lamp on the back of the acrylic word and fix it with screws or sealant

6. Finally, select the appropriate power according to the power of the LED lamp;